11/15/2011
Weston, FL

If you have the 2012 GW, you must to buy this! Installing the FACTORY HONDA CB (not the aftermarket one) is much easier on the 2012 models! The seat does not have to be removed! The new bikes have the Audio Control Unit (ACU) mounted in the trunk well, above the location for the CB. The ACU does not have to be disconnected, just 4 mounting screws and the whole ACU lifts enough to locate the CB beneath it. The CB control cable plugs into the ACU and the CB power connector is in the well with the ACU. Plug 'N play! Instructions to remove the seat and the left hand armrest, Drill a hole, feed the antenna out the front of the trunk and back in to the trunk in the same hole the ACU harness enters the well. But if you route the antenna cable inside the front left corner of the trunk, the armrest, pocket, and the seat do not have to come off. Just drill the 3 holes to mount the antenna, install the ground strap for the antenna, and you are done. The CB kit does not have the RF chokes either; evidently the new models already have them installed.